Filter
Top Products
Figure 26. Removing and Installing a Server Module
1. release button
2. PCIe label on server module
NOTE: This label indicates that the
server module is configured specifically
for the VRTX enclosure.
3. guide rail on server module (or server module
blank)
4. guide rail on enclosure
5. server module handle
Configuring A Server Module
NOTE: Follow this procedure to install PowerEdge M520 or M620 server modules that are not configured for the
VRTX enclosure.
NOTE: If you install PowerEdge M520 or M620 server modules that are not configured for the VRTX enclosure, an
error message is displayed.
To configure a server module for the VRTX enclosure:
1. Open the server module.
For more information on opening a server module, see the server module's Owner's Manual at dell.com/
poweredgemanuals.
2. Remove any mezzanine cards installed in Fabric B and Fabric C slots of the server module.
3. Install PCIe Mezzanine cards in the vacant Fabric B and Fabric C slots.
For more information on installing the PCIe Mezzanine cards, see the server module's Owner's Manual at dell.com/
poweredgemanuals.
48