Filter
Top Products
Driver Installation 45
5
Select the
System Type
,
Operating System
,
Driver Language
,
and
Category
from the drop-down list.
6
The drivers that are applicable to your selection are displayed. From the
available list, download the drivers that you require to a diskette drive,
USB drive, CD, or DVD.
7
During the operating system installation, use the media that you created
with the
Load Driver
option to load mass storage drivers. For more
information on reinstalling the operating system, see the relevant section
for your operating system below.
Installing Driver During a Windows Server 2008, Windows Server 2008
R2 Installation
1
Boot the system using the Windows Server 2008, or Windows Server 2008
R2 media.
2
Follow the on-screen instructions until you reach
Where do you want to
install Windows Server 2008
window
and then select
Load driver
.
3
The system prompts you to insert the media. Insert the installation media
and browse to the proper location.
4
Select the appropriate PERC H310, H710, H710P, or H810 card from the
list, click
Next
and continue installation.
Installing Windows Server 2008 or Windows Server 2008 R2 for a New
RAID Controller
Perform the following steps to configure the driver for the RAID controller on
a system that already has Windows installed:
1
Turn off the system.
2
Install the new RAID controller in the system.
For detailed instructions on installing and cabling the RAID controller in
the system, see "Deploying the PERC Card" on page 35.
3
Turn on the system.
4
The
Found New Hardware Wizard
screen displays the detected hardware
device.
5
Click
Next
.