Filter
Top Products
Appendix 147
Japan Standard
STD-T66 (Ver 1.0)
Canada—Industry Canada (IC)
This device complies with RSS210 of Industry Canada. Operation of the device is subject to
the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may cause undesired operation.
FCC Standard
47 CFR Part 15, Subpart C (Section 15.247). This version is limited to channel 1 to
channel 11 by specified firmware controlled in the U.S.A.
Federal Communications Commission (FCC)
This device complies with Part 15 of the FCC Rules. Operation of the device is subject to the
following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may cause undesired operation.
NOTE: The radiated output power of this Dell Axim X50 device is far below the FCC radio
frequency exposure limits. Nevertheless, the Dell Axim X50 device should be used in such a
manner that the potential for human contact during normal operation is minimized. To determine
the location of the antenna within your computer, check the information posted on the general
Dell support site at support.dell.com.
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. If the equipment is not installed and used in
accordance with the instructions, the equipment may cause harmful interference to radio
communications. There is no guarantee, however, that such interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception (which can be determined by turning the equipment off and on), the user is
encouraged to try to correct the interference by taking one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.