Filter
Top Products
Back to Contents Page
Display
Dell™XPS™L502XServiceManual
Display Assembly
Display Bezel
Display Panel
Display Cable
Display-Panel Brackets
Display Assembly
Removing the Display Assembly
1. Follow the instructions in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the module cover (see Removing the Module Cover).
4. Remove the memory module(s) (see Removing the Memory Module(s)).
5. Disconnect the antenna cables from the Mini-Cards.
6. Note the routing of the Mini-Card antenna cables and remove them from the routing guides on base cover.
7. Remove the two screws that secure the display assembly to the base cover.
8. Remove the palm-rest assembly (see Removing the Palm-Rest Assembly).
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
antenna cables
2
base cover
CAUTION: Be extremely careful when opening the display to prevent damaging the display assembly.