Filter
Top Products
Replacing the Hard Drive
1. Follow the instructions in Before You Begin.
2. Remove the new hard drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
3. Slide the hard drive into the hard-drive bracket.
4. Replace the four screws that secure the hard-drive bracket to the hard drive.
5. Place the hard-drive assembly in the hard-drive bay.
6. Slide the hard-drive assembly to connect it to the system board connector.
7. Replace the four screws that secure the hard-drive assembly to the computer base.
8. Replace the palm-rest assembly (see Replacing the Palm-Rest Assembly).
9. Replace the battery (see Replacing the Battery).
Back to Contents Page
1
screws (4)
2
hard-drive bracket
3
hard drive
CAUTION: When the hard drive is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge"
in the safety instructions that shipped with your computer).
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.