Filter
Top Products
Error Code Message Information
SEL0010
Message Log is almost full.
Details When the event log is full, additional events are not written to the log. Older events may be
overwritten and lost.
Action Backup and clear log at the next maintained time.
SEL0012
Message Could not create or initialize the system event log.
Details If the system event log fails to initialize, platform status and failure events are not captured.
Some management software do not report platform exceptions.
Action Reboot the management controller or iDRAC. Cycle system input power. If problem persists
call support.
SEL1204
Message An unknown system hardware failure detected.
LCD Message Unknown system hardware failure.
Details If the system event log failed to initialize platform status and failure events are not
captured. Some management software will not report platform exceptions.
Action Re-configure system to minimum supported configuration. If issues persists, contact
support.
SEL1209
Message The platform event filter action failed.
Details System policies or permissions may prevent the action from executing. If configured, the
system does not execute the action on a platform event (such as power down, cycle,
interrupt, and send alert).
Action Review platform event configuration.
SEL1211
Message The time-stamp clock could not be synchronized.
Details The time stamp on system event log events may not correlate to the system time.
Action Cycle system input power. If problem persists, contact support.
SEL1300
Message No bootable media found.
Details System setup displays the system boot order. The local video screen may also show
additional information. (IPMI sensor type code 1eh - offset 00h).
Action Check system boot settings. Check if mass storage controller configuration settings are
applicable.
SEL1302
Message Non-bootable diskette detected.
Details The disk in the drive is not formatted correctly or does not contain the necessary operating
system files.
Action Replace diskette with a bootable disk.
115