Filter
Top Products
72 Configuration: About Your Storage Array
Naming or Renaming Storage Arrays
Each storage array should be assigned a unique up to 30-character
alphanumeric name. A name can consist of letters, numbers, and the special
characters underscore (_), dash (–), and pound sign (#). No other special
characters are allowed.
To rename a selected storage array:
1
Perform one of these actions:
• In the AMW
Setup
tab, select Rename Storage Array.
•In the EMW
Devices
tab Tree view, select
Edit
Rename.
•In the EMW
Devices
tab Table view, select
Edit
Rename.
•In the EMW
Devices
tab Tree view, right-click on the desired array
icon and select
Rename.
The
Name/Rename Storage Arrays
dialog appears.
2
Select the relevant storage array from the
Select storage array
table.
If you do not know the name or physical location of the storage array, click
Blink
. After locating the storage array, click
OK
to turn off the LEDs.
The name of the storage array appears in the
Storage array name
.
3
In
Storage array name
, type the new name of the storage array. If
applicable, add a comment for the storage array in
Additional comment
.
4
Click
Apply
.
A message is displayed warning you about the implications of changing the
storage array name.
5
Click
Yes
.
The new storage array name appears in the
Select storage array
table.
6
Repeat step 2 through step 4 to name or rename additional storage arrays.
NOTE: Avoid arbitrary names or names that might lose meaning in the future.
book.book Page 72 Wednesday, June 8, 2011 5:01 PM