Dell MD3600F Computer Hardware User Manual


 
Configuration: About Your Storage Array 81
9
For the selected e-mail address, in
Frequency
, select:
Every event
—Sends an alert e-mail whenever an event occurs. This is
the default option.
Every x hours
—Sends an alert e-mail after the specified time interval
if an event occurred during that time interval. You can select this
option only if you have selected either
Event + Profile
or
Event +
Support
in the
Information To Send
drop down list.
10
Click
OK
.
An alert icon appears next to each node in the Tree view where an alert is set.
To ensure that the e-mail is sent successfully:
You must provide a SMTP mail server name and an e-mail sender address
for the e-mail addresses to work.
The e-mail addresses that you had previously configured appear in the
Configured e-mail addresses area.
You must use fully qualified e-mail addresses, for example,
name@mycompany.com.
You can configure multiple e-mail addresses before you click
OK
.
Configuring SNMP Alerts
To add a management console to the list of addresses configured to receive
SNMP alerts:
1
Open the
Configure Alerts
dialog by performing one of these actions:
In the Tree view or the Table view on the
Devices
tab in the EMW,
select a node, and select
Edit
Configure Alerts
. Go to step 3.
•In the
Setup
tab in the EMW, select
Configure Alerts.
Go to step 2.
2
Select one of the following radio buttons to specify an alert level:
All storage arrays
—Select this option to send an alert notification
about events on all storage arrays.
An individual storage array
—Select this option to send an alert
notification about events that occur in only a specified storage array.
book.book Page 81 Wednesday, June 8, 2011 5:01 PM