Setting Up and Using Your Computer 51
1 Pull the cap off the track stick.
2 Align the new cap over the square track stick post and gently press the
cap down onto the post.
NOTICE: The track stick can damage the display if it is not properly seated
on the post.
3
Test the track stick to ensure that the cap is seated properly.
Enabling the Infrared Sensor
1 Enter the system setup program:
a Turn on your computer.
b Press when the Dell™ logo appears.
HINT: You cannot use the
infrared sensor when the
computer is docked.
2 Press until you locate Infrared Data Port under Basic
Device Configuration.
3 Press the down-arrow key to highlight Disabled next to Infrared Data
Port.
1H018bk3.book Page 51 Monday, October 14, 2002 2:26 PM