Filter
Top Products
46 Installing System Components
Figure 3-4. Rotating the Hard-Drive Carrier Out of and Into the System
Rotating the Hard-Drive Carrier Into the System
1
Grasp the handle on the hard-drive carrier and rotate the carrier back into the chassis until the metal
tabs on each side of the carrier are seated, securing the carrier. See Figure 3-4.
2
Pull up on the card retention mechanism to release it from the hard-drive carrier.
3
Rotate the card retention mechanism back into its original position; push its tip so that its tab clicks
into place. See Figure 3-4.
4
Reconnect the P3 power-cable connectors.
Removing and Replacing the Front Drive Bezel
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for
complete information about safety precautions, working inside the computer and protecting against electrostatic
discharge.
1
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 43."
NOTE: This sliding plate secures and releases the drive bezel and helps to secure the drives.
3
Pull the lever on the sliding plate to the right until it releases the front drive bezel from its side hinges.
1 rotatable hard-drive carrier 2 handle 3 card-retention mechanism
3
2
1
book.book Page 46 Monday, June 5, 2006 1:51 PM