Filter
Top Products
80 Installing System Components
5
Remove the system battery.
NOTICE: To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
a
S
upport the battery connector by pressing down firmly on the positive side of the connector.
See
Figure 3-24
.
b While supporting the battery connector,
push t
he battery toward the positive side of the
connector and pry it up out of the securing tabs at the negative side of the connector.
Figure 3-24. Replacing the System Battery
6
I
nstall the new system battery (see Figure 3-24):
a
Support the battery connector by pressing down firmly on the positive side of the connector.
b
Hold the battery with the "+" facing up, and slide it under the securing tabs at the positive side of
the connector.
c
Press the battery straight down into the connector until it snaps into place.
7 Replace all the expansion cards you removed in
step 4
. See "Installing an Expansion Card
" on page 70
.
8 Close the system. See
"Closing the System" on page 43
.
9
Reconnect the system to the electrical outlet and turn on the system and attached peripherals.
10
Enter the System Setup program to confirm that the battery operates properly.
11
From the main screen, select
System Time
to enter the correct time and date.
12
Re-enter any system configuration information that is no longer displayed on the System Setup
screens, and then exit the System Setup program.
13 To test the newly installed battery, see
"Troubleshooting the System Battery" on page 102
.
1 positive side of connector 2 system battery 3 negative side of connector
2
3
1
book.book Page 80 Monday, June 5, 2006 1:51 PM