Filter
Top Products
Figure 10. Removing the battery
1. battery carrier 2. guide on the battery carrier (2)
3. battery 4. battery cable
8. Align the replacement battery with the guides on the battery carrier.
9. Lower the battery into the carrier until the battery clicks into place.
10. Align the tabs on the battery carrier with the slots on the PERC9 mini monolithic controller and lower
the battery carrier till it clicks into place.
11. Connect the battery cable to the PERC card.
12. Replace the PERC card. For more information, see Installing the PERC 9 mini monolithic controller.
13. Close the system.
14. Reconnect the system to its electrical outlet and turn on the system, including any attached
peripherals.
Installing the PERC 9 mini monolithic controller
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet.
NOTE: It is recommended that you always use a static mat and static strap while working on
components in the interior of the system.
2. Open the system.
3. Locate the PERC 9 card connector on the system board and align one end of the card with the card
holder on the system board.
44