Dell UCSA-901 Computer Hardware User Manual


 
Figure 13. Removing and installing the PERC 9 mini blade controller
1. hard-drive/SSD backplane cable
connector
2. slot on the PCIe extender/storage
controller card
3. tabs on the PCIe extender/storage
controller card support bracket
4. standoff (2)
Replacing the tethered battery of a PERC 9 mini blade card
The tethered battery attached to the PERC 9 mini blade card can be replaced. This tethered battery
feature is applicable only to the PowerEdge FC630 and FC830 systems.
1. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
NOTE: It is recommended that you always use a static mat and static strap while working on
components in the interior of the system.
2. Open the system.
3. Locate the battery carrier of the PERC card on the system board.
4. Push the tab on the battery carrier forward until the battery carrier disengages from the slot of the
chassis.
49