Filter
Top Products
Figure 17. Replacing the battery carrier
1. battery carrier 2. tab on the battery carrier
3. guide slot on the chassis 4. guide pins on the chassis
9. Connect the battery cable to PERC 9 mini blade controller.
10. Close the system.
11. Reconnect the system to its electrical outlet and turn on the system, including any attached
peripherals.
Installing the PERC 9 mini blade controller
1. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet.
NOTE: It is recommended that you always use a static mat and static strap while working on
components in the interior of the system.
2. Open the system.
3. Remove the NDC riser.
4. Lift the clamp attached to the power supply bay and locate the PERC 9 card connector on the
system board.
53