Filter
Top Products
Memory Module(s) | 33
Replacing the Memory Module(s)
Procedure
1 Align the notch on the memory module with the tab on the
memory-module connector.
2 Slide the memory module firmly into the connector at a 45-degree angle, and press
the memory module down until it clicks into place. If you do not hear the click,
remove the memory module and reinstall it.
NOTE: If the memory module is not installed properly, the computer may
not boot.
3 Insert the tabs on the memory-module shield into the slots on the
system-board shield and then slide the memory-module shield toward the bottom
of the computer. Ensure that the screw hole on the memory-module shield aligns
with the screw hole on the system-board shield.
4 Replace the screw that secures the memory-module shield to the
system-board shield.
Postrequisites
1 Replace the back cover. See "Replacing the Back Cover" on page 20.
2 Replace the stand. See "Replacing the Stand" on page 18.
3 Replace the stand cover. See "Replacing the Stand Cover" on page 16.
4 Follow the instructions in "After Working Inside Your Computer" on page 13.
1tab 2notch
1
2
book.book Page 33 Monday, October 8, 2012 4:27 PM