Filter
Top Products
38 | Antenna-In Connector
Replacing the Antenna-In Connector
Procedure
1 Slide the antenna-in connector into the slot on the system-board shield.
2 Replace the hex nut that secures the antenna-in connector to the
system-board shield.
Postrequisites
1 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 36.
2 Replace the back cover. See "Replacing the Back Cover" on page 20.
3 Replace the stand. See "Replacing the Stand" on page 18.
4 Replace the stand cover. See "Replacing the Stand Cover" on page 16.
5 Follow the instructions in "After Working Inside Your Computer" on page 13.
book.book Page 38 Monday, October 8, 2012 4:27 PM