Filter
Top Products
2-12
Cisco BBSM Hotspot 1.0 User Guide
78-15293-01
Chapter 2 Setting Up BBSM Hotspot
Running the Setup Wizard
Figure 2-10 Enter Network Device Configuration Parameters Window
Step 12 Enter the network device parameters, as described in Table 2-5. The wizard uses this data to determine
the number of IP addresses to allocate to the network device range. (This may have been familiar to
current BBSM customers as the “Management Range.”) This information will also be used in the switch
discovery part of the wizard.
Step 13 Click Next. The Calculating Internal Network Address Ranges window appears, providing you with a
list of the internal IP address ranges that have been calculated and assigned by the BBSM Hotspot server.
These include the following:
• Network Device Addresses—These addresses are allocated to the network devices. This address
range is allocated from the “Number of Network Devices” number entered in Step 12.
Table 2-5 Enter Network Device Configuration Descriptions
Field Description
Number of Network Devices Enter the total number of switches and wireless access points that will
be installed on the BBSM internal network. You can also enter a larger
number than the current amount of network devices in anticipation of
additional devices in the future.
SNMP Password Enter the SNMP password that is used to access network devices.
BBSM Hotspot needs this information to run switch discovery. Note
that on Cisco Catalyst switches, the SNMP password is also known as
the SNMP community read/write string.