Filter
Top Products
31
2
Hardware Installation
S/PDIF
W
W
The system board is equipped with an onboard optical S/PDIF-out
port at location CN9. It is also equipped with a connector at loca-
tion SPDIF1 for coaxial RCA S/PDIF-in/out port connection. S/PDIF
ports are used to connect audio output devices.
Your coaxial RCA S/PDIF ports may come mounted on a card-edge
bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable connector to
SPDIF1. Make sure pin 1 of the audio cable connector is aligned
with pin 1 of SPDIF1.
Important:
DO NOT use optical S/PDIF and coaxial RCA S/PDIF at the same
time.
Optical S/PDIF
1
5
SPDIF in
GND
SPDIF out
Key
+5V