Filter
Top Products
50
2
Hardware Installation
The system board supports the chassis intrusion detection function.
Connect the chassis intrusion sensor cable from the chassis to the
chassis open connector. Whenever a chassis component has been
removed, the sensor sends signal to the connector alerting you of a
chassis intrusion event.
Hardware Doctor
Install the “Hardware Doctor” utility. By default, the chassis intrusion
detection function is disabled. When enabled, a warning message will
appear when the chassis is open. The utility can also be configured
so that a beeping alarm will sound when the chassis is open. Refer
to the “Hardware Doctor” section in chapter 4 for more information.
Chassis Open Connector
X
2
1
Ground
Chassis signal