Dialogic SX-2000 Network Card User Manual


 
Dialogic
®
4000 Media Gateway Series Integration Note
35
Configure the form as follows:
Note: Parameters not listed below can be left at their default settings.
Select as Circuit number 1, and as Cabinet number, Shelf number, and Slot number the number in which the
T1 QSIG line is being installed.
Set Trunk Num to an unused trunk number that has at least 22 unused trunk numbers available after it
(e.g., if you select 100, 101-122 must also be available).
Set Trunk Service Number to the trunk service number defined in Step 9 of SX-2000 Light
Administration.
Set Circuit Desc. Number to the circuit descriptor number defined in Step 8 of the SX-2000 Light
Administration.
Set Interconnect Number to a valid interconnect number.
Press [ESC] then [2] to define the range programming, a RANGE PROGRAMMING Parameters data entry
field will appear in the main screen.
Set Trunk Num to the trunk number defined earlier in this step, and press [TAB].
Set the Trunk Service Number to 0, and press [TAB].
Set Circuit Desc. Number to 0, and press [TAB].
Set Interconnect Number to 0, and press [TAB].
Set Comp Zone IO to 0, and press [TAB].
Set Tenant Number to 0, and press [TAB].
Press [ESC] then [2] to define the range programming, a Specify number of lines data entry field will
appear in the main screen.
Set Specify number of lines to 22 and press [ENTER]
Press [ESC] then [4] to execute the command.