Dialogic SX-2000 Network Card User Manual


 
Mitel SX-2000 Lightware
46
Under Options, select Network-side Interface and Qsig.
Click Update and then Close.
Step 3: Configure the PRI Link Characteristics as follows:
Select Config > System Configuration > PRI Link Characteristics.
Note: Parameters not listed below can be left at their default settings.
Set PRI link number* to the link number in which the T1 Q.SIG is installed.
Set Protocol Type to QSIG.
Set Protocol Variant to ISO.
Set Physical Type to T1/CSU.
Select Network-side / Qsig master.
Click the Characteristics button.
Configure the T1/CSU Characteristics as follows: