Filter
Top Products
DFL-500 User Manual
14
Data bits
8
Parity
None
Stop bits
1
Flow control
None
•
Press Enter to connect to the DFL-500 CLI.
The following prompt appears:
DFL-500 login:
• Type admin and press Enter.
The following prompt appears:
Type ? for a list of commands.
For information on how to use the CLI, see the DFL-500 CLI Reference Guide .
Next steps
Now that your DFL-500 NPG is up and running, you can proceed to configure it for operation:
• If you are going to run your DFL-500 NPG in NAT/Route mode, go to NAT/Route mode installation
.
• If you are going to run your DFL-500 NPG in Transparent mode, go to Transparent mode installation
.