D-Link DFL-500 Network Card User Manual


 
DFL-500 User Manual
6
3
Allow
outbound
Select Allow outbound to enable outbound users to connect to the destination address.
Inbound
NAT
The DFL-500 NPG translates the source address of incoming packets to the IP address of the
DFL-500 interface connected to the source address network.
Outbound
NAT
The DFL-500 NPG translates the source address of outgoing packets to the IP address of the
DFL-500 interface connected to the destination address network.
Use the information in Adding NAT/Route mode policies to configure the remaining policy settings.
Select OK to save the encrypt policy.
To make sure that the encrypt policy is matched for VPN connections, arrange the encrypt policy
above other policies with similar source and destination addresses in the policy list.
Viewing VPN tunnel status
You can use the IPSec VPN tunnel list to view the status of all IPSec AutoIKE key VPN tunnels. For each
tunnel, the list shows the status of each tunnel as well as the tunnel time out.
To view VPN tunnel status:
Go to VPN > IPSEC > AutoIKE Key .
The Status column displays the status of each tunnel. If Status is Up, the tunnel is active. If Status is
Down, the tunnel is not active.
The Timeout column displays the time before the next key exchange. The time is calculated by
subtracting the time elapsed since the last key exchange from the keylife.