Filter
Top Products
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config serial_port
Purpose Used to configure the serial port.
Syntax
config serial_port {auto_logout [never | 2_minutes |
5_minutes | 10_minutes | 15_minutes]}
Description This command is used to configure the serial port’s baud rate
and auto logout settings.
Parameters auto_logout – The user may select a time period from the
following list which the Switch will automatically log out of the
serial port.
• never − No time limit on the length of time the console can
be open with no user input.
• 2_minutes − The console will log out the current user if
there is no user input for 2 minutes.
• 5_minutes − The console will log out the current user if
there is no user input for 5 minutes.
• 10_minutes − The console will log out the current user if
there is no user input for 10 minutes.
• 15_minutes − The console will log out the current user if
there is no user input for 15 minutes.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure baud rate:
DES-6500:4#config serial_port baud_rate 115200
Command: config serial_port baud_rate 115200
Success.
DES-6500:4#
enable clipaging
Purpose Used to pause the scrolling of the console screen when the show
command displays more than one page.
Syntax
enable clipaging
Description This command is used when issuing the show command which
causes the console screen to rapidly scroll through several
pages. This command will cause the console to pause at the end
of each page. The default setting is enable.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable pausing of the screen display when the command output reaches the end of the page:
17