Filter
Top Products
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config access_profile profile_id (IP)
packet to see if it will be either forwarded or filtered based on one or
more of the following:
• vlan <vlan_name 32> − Specifies that the access profile will
apply to only to this VLAN.
• source_ip <ipaddr> − Specifies that the access profile will
apply to only packets with this source IP address.
• destination_ip <ipaddr> − Specifies that the access profile will
apply to only packets with this destination IP address.
• dscp <value 0-63> − Specifies that the access profile will apply
only to packets that have this value in their Type-of-Service
(DiffServ code point, DSCP) field in their IP packet header.
• icmp − Specifies that the Switch will examine the Internet
Control Message Protocol (ICMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will
apply to this ICMP type defined by a value between 0 and 255.
• code <value 0-255> − Specifies that the access profile will
apply to this ICMP code defined by a value between 0 and
255.
• igmp − Specifies that the Switch will examine the Internet
Group Management Protocol (IGMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will
apply to packets that have this IGMP type defined by a value
between 0 and 255..
• tcp − Specifies that the Switch will examine the Transmission
Control Protocol (TCP) field within each packet.
• src_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this TCP source port in
their TCP header.
• dst_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this TCP destination port in
their TCP header.
• flag_mask – Enter the type of TCP flag to be masked. The
choices are:
• urg: TCP control flag (urgent)
• ack: TCP control flag (acknowledgement)
• psh: TCP control flag (push)
• rst: TCP control flag (reset)
• syn: TCP control flag (synchronize)
• fin: TCP control flag (finish)
• udp − Specifies that the Switch will examine the Universal
Datagram Protocol (UDP) field in each packet.
• src_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this UDP source port in
their header.
• dst_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this UDP destination port in
218