Filter
Top Products
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config route redistribute dst rip src
Parameters
src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} −
Allows the selection of the protocol of the source device. The user
may choose between:
metric <value 0-16> − Allows the entry of an OSPF interface cost.
This is analogous to a Hop Count in the RIP routing protocol.
Restrictions Only administrator-level users can issue this command.
• all – Specifies both internal an external.
• internal – Specifies the internal protocol of the source device.
• external - Specifies the external protocol of the source
device.
• type_1 - Calculates the metric (for RIP to OSPF) by adding
the destination’s interface cost to the metric entered in the
Metric field.
• type_2 - Uses the metric entered in the Metric field without
change. This field applies only when the destination field is
OSPF.
• inter+e1 – Specifies the internal protocol AND type 1 of the
external protocol.
• inter+e2 – Specifies the internal protocol AND type 2 of the
external protocol.
Example Usage:
To configure route redistributions:
DES-6500:4#config route redistribute dst ospf src rip mettype
type_1 metric 2
Command: config route redistribute dst ospf src rip mettype
type_1 metric 2
Success.
DES-6500:4#
delete route redistribute
Purpose Used to delete an existing route redistribute configuration on the
Switch.
Syntax
delete route redistribute {dst [rip | ospf] src [rip | static | local
| ospf]}
Description This command will delete the route redistribution settings on this
switch.
Parameters
dst [rip | ospf] − Allows the selection of the protocol on the
destination device. The user may choose between RIP and OSPF.
src [rip | static | local | ospf] − Allows the selection of the protocol
on the source device. The user may choose between RIP, static,
local or OSPF.
Restrictions Only administrator-level users can issue this command.
275