Echo LANlink Router Option User Manual Issue 1.0 04 December 1997 Page 18 of 59
3.2 Internal Link LK13
Locate the internal connector LK13 on the motherboard (refer to Figure 9). This
will be fitted with shorting links if the Echo LANlink was supplied without the
Router Option. Remove the shorting links before fitting the Router Option. The
links may be repositioned on one pin for storage.
3.3 Installing the Router Option
Remove the option blanking plate above the CH 1 and CH2 connectors on the
rear panel of the multiplexer. The blanking plate may be discarded if not required.
The Router Option card should be carefully fitted in the position shown in Figure
10, connecting to J10 and J15 on the motherboard (refer to Figure 9). The Router
Option power connector (flying lead) should be connected to J12 (ensure correct
polarisation). Refit the rear panel screws to secure the option card
Router
Option
J12
Figure 10 Echo LANlink showing Router Option Fitted