Filter
Top Products
Echo LANlink Router Option User Manual Issue 1.0 04 December 1997 Page 58 of 59
I.5 Set New IP Address
Selecting this option will allow the Manager to set a new IP address for the
Router if required to facilitate the file transfer. Note the burnt in MAC address
will be used in the Maintenance mode.
I.6 Set Default Gateway
Selecting this option will allow the Manager to set a default gateway (should
RIP not be transmitted) for the Router if required to facilitate the file transfer.
I.7 Run Flash Program
This will reboot the Router.
I.8 Reset Password
In order to give the network manager the ability to reset the Password on the
Router the factory uses a unique system to reset the default password to
SYSTEM. Using the number gives the user two minutes, and one attempt to
reset the password to SYSTEM.
Type 9 and press <RETURN>
This will display:
Enter Key: 9
Unit Serial: ****
Enter Magic Number:
Type in the unique Magic Number supplied with the Router option, or a copy
obtained from your distributor.
Press 8 <RETURN> to reboot the Router, and access the Security Menu to
reset the password.
I.9 Boot File Using TCP Loader
This is for factory use only