Filter
Top Products
Echo LANlink Router Option User Manual Issue 1.0 04 December 1997 Page 57 of 59
Erasing Flash Memory
Programming Flash Memory
Verifying Flash Memory
Flash Memory OK
AN8100B Small Office Server Maintenance Menu Vx.x
1) Update Flash from Console port with Kermit
2) Update Flash from Ethernet with TCP Loader
3) Update Flash from Ethernet with TFTP Loader
4) Restore configuration from Ethernet via TFTP
6) Set new IP Address (xx.xx.xx.xx)
7) Set default Gateway (xx.xx.xx.xx)
8) Run Flash Program
9) Reset Password
B) Boot File using TCP Loader
C) Boot File using TFTP Loader
M)Run monitor
Enter Key:
Type in 8 to run the new revision of software.
I.2 Download New Firmware using TCP loader
This option is for factory use only.
I.3 Download New Firmware using TFTP
Selecting this option will allow the Manager to TFTP software upgrades to the
Router. The Router will act as a server, enabling the files to be downloaded
from the PC in Binary or Octet formats (not ASCII.)
I.4 Restore Configuration using TFTP
The configuration for Router is stored in the EEPROM. This configuration
may also be saved to a PC. This must be carried out while the Router is
operational (see the Security Section for set-up details.) Restoration must be
carried out in the Maintenance mode.
Selecting this option will allow the Manager to TFTP to the Router a stored
configuration. The Router will act as a server, enabling the files to be
downloaded from the PC in a Binary or Octet formats (not ASCII.)