Filter
Top Products
6.7:
Display
Features
Mode
Q
Use the MODE button to access the Display Features Mode from other Modes. Use the UP/DOWN
arrows to navigate from Group to Group within this Mode. See section 6.8 for a navigational map of
the Display Features mode.
Q
Group 1: Reset Max/Min
• Note
: If the password protection feature has been enabled with the Communicator EXT
software, you will need to enter a password to reset the max/min readings. To do this, first press
the Enter button. Then enter the password, one character at a time, by pressing on the UP or
DOWN arrows. Each password character begins as an “A”. Press the UP arrow to increment the
character from “A–Z” and then from “0–9”. Press the DOWN arrow to decrement the character
from “A” to “9–0” and then from “Z–A”. Press SET to enter each character the password. When
the entire password is shown on the Display screen, press ENTER. If the password is correct you
may then press Enter again to Reset the Energy readings.
• Press the Enter button to reset the Max and Min values.
Q
Group 2: Reset Energy
• Note
: If the password protection feature has been enabled with the Communicator EXT
software, you will need to enter a password to reset the energy. To do this, first press the Enter
button. Then enter the password, one character at a time, by pressing on the UP or DOWN
arrows. Each password character begins as an “A”. Press the UP arrow to increment the
character from “A–Z” and then from “0–9”. Press the DOWN arrow to decrement the character
from “A” to “9–0” and then from “Z–A”. Press SET to enter each character the password. When
the entire password is shown on the Display screen, press ENTER. If the password is correct you
may then press Enter again to Reset the Energy readings.
• Press Enter button to reset the Max and Min values.
Q
Group 3: Display Baud Rate/Address
Q
Group 4: Display Communication Protocol
Q
Group 5: EIG Use Only
Q
Group 6: EIG Use Only
Q
Group 7: Lamp Test
• Press Enter to conduct an LED test.
Q
Group 8: Display Scroll ON/OFF
• Press Enter to turn the scroll feature on or off. When the scroll feature is on, the P40N External
Display will scroll through the first reading of each group in the Dynamic Readings Mode. If a
button is pressed during the scroll, scrolling pauses for one minute.
Electro Industries/GaugeTech
Doc # E107706 V1.25 6-8