EMC QLA23xx Network Card User Manual


 
2
2-16
EMC Fibre Channel with QLogic HBAs in Windows Hosts
Installing and Configuring the HBA Driver
Windows 2000 configurations with Service Pack 1 or higher and
Windows 2003 configurations may be able to detect QLA23xx HBAs. If
this occurs, the HBA will already be listed under SCSI Devices; instead
of proceeding with these installation steps, follow the instructions under
Updating the HBA Driver in a Windows 2000 or Windows 2003 Host on
page 2-17.
5. Double-click the first instance of SCSI Controller under Other
Devices.
6. In the next window, click ReInstall Driver, then Next.
7. Select Display a list of the known drivers for this device so that
I can choose a specific driver, then click Next.
8. Select SCSI and RAID Controllers, then click Next.
9. Click Have Disk.
10. Enter the path to the diskette containing the driver (for example,
A:\), then click OK.
11. Select the appropriate QLogic HBA from the list of drivers that
appears; then click Next.
12. Click Next in the next window.
13. Click YES to continue the installation.
14. Click Finish to complete the driver installation.
15. The system requests that you reboot the system. Select NO and
click Close.
16. The system again requests that you reboot the system. Select NO
again.
17. If there are other QLogic HBAs installed, repeat steps 5 through
16 until all adapters have been installed.
18. Reboot the host.