Filter
Top Products
3
Configuring a Symmetrix Boot Device
3-9
Configuring an EMC Boot Device
HP ProLiant BL20p G2
Windows 2000
Installation
1. Note these prerequisites:
• RDP server with release 1.30
• BfS Installation script, see HP ProLiant BL20p G2
documentation for creation and installation of this script.
2. Configure BL20p G2. Then reboot the BL20p G2 and select F9 to
RBSU (F10 to save all changes before exit).
a. Select Set Boot Controller Order
i. Ctrl:1 PCI Dual Port Fibre..Port 1
ii. Ctrl:2 PCI Dual Port Fibre..Port 2
iii. Ctrl:3 HP Smart Array 5i Ctrl
b. Set IPL order as follows:
i. PCI Embedded HP NC7781 Gig Server Adapter Port 1
ii. CD-ROM
iii. Floppy Drive
iv. Hard Drive C:
3. Install the Windows 2000 OS:
a. If there is a local hard drive installed, remove it. This drive can
be reinserted after the installation is completed.
b. Open an interface window using the RDP console by
Right-clicking the target server and selecting Power Control/
RILOE Interface.
c. Delete the target server (BfS Server) from the RDP database if
it exists.
d. Reboot the BfS server. (At boot time, the newly created LUN
should be detected.)
The BfS server should now be seen in the RDP New Computer
pane.
e. Start the BfS deployment by dragging and dropping the
BOOT
FROM SAN BL20p
script task to the BfS server new computer
Installation time is approximately 50 minutes.