Filter
Top Products
50
MODEL 5081-T SECTION 7.0
PROGRAMMING
SECTION 7.0
PROGRAMING
7.1 General
7.2 Output
7.3 Temp
7.4 Display
7.5 HART
7.6 Setup Cust
7.7 Range
7.8 Default
7.1 GENERAL
This section describes how to do the following:
1. assign values to the 4 and 20 mA outputs (for 5081-T-HT only)
2. set the current generated by the transmitter during hold (for 5081-T-HT only)
3. set the current generated by the transmitter when a fault is detected (for 5081-T-HT only)
4. enable and disable automatic temperature correction
5. program the type measurement
6. program HART digital communications
7. set measurement range to automatic (default) or specific conductance ranges
8. reset all settings to factory default condition
Model 5081-T-HT Model 5081-T-FF
99VVUU::VVUU UU1177::
UU1177:: 00LL<<::[[--AA
00LL<<::[[--AA <<11UUVV::!
!
//VV<<UU
44--;;==
001122--VV[[UU
<<11UUVV::!
!
//VV<<UU
SS--PPJJ11
001122--VV[[UU
SS--PPJJ11