Emerson 5081-T Switch User Manual


 
66
MODEL 5081-T SECTION 9.0
OPERATION WITH MODEL 375
Transducer Error
ST_REV
BLOCK_ERR
Additional transmitter status
Fault history 0
Fault history 1
Fault history 2
Block Mode
MODE_BLK: Actual
MODE_BLK: Target
MODE_BLK: Permitted
STRATEGY
ALERT_KEY
Characteristics Block Tag
TAG_DESC
Measurements
Prim Val Type
Primary Val: Primary Val
Primary Val: Status
Primary Value Range: EU at 100%
Primary Value Range: EU at 0%
Secondary variable: Value
Secondary variable: Status
Raw RTD Ohms
Raw PV: Raw PV
Raw PV: Status
Conductance
Calibration
PV Cal
Sensor Zero
SV Cal
Calibrate Meter
Configuration
Change PV Type
Sensor type conductivity
Prim Val Type
Conductivity unit
Diagnostic override
Calibration Parameters
Cell constant
Conductance offset
Solution/Conductivity offset
Input cal factor
Temperature calibration offset
Snsr Cal Meth
Snsr Cal Date
Temperature Compensation
Secondary value units
Sensor temperature compensation
Sensor temp manual value
Temp comp type
Temperature slope
Raw RTD ohms
Sensor type temp
Custom Curve
Reset transducer/Load factory defaults
Identification
Software revision level
Hardware revision level
LOI security code
Sensor S/N
Final assembly number
AI blocks simulation
AI1
AI2
AI3
Quick Config
AI Channel
L_TYPE
XD_SCALE: EU at 100%
XD_SCALE: EU at 0%
XD_SCALE: Units Index
XD_SCALE: Decimal
OUT_SCALE: EU at 100%
OUT_SCALE: EU at 0%
OUT_SCALE: Units Index
OUT_SCALE: Decimal
Common Config
ACK_OPTION
ALARM_HYS
FIGURE 9-3. 5081-C/T-FF/FI Model 375 Menu Tree (2 of 10)