Filter
Top Products
Hardware Overview
32 Enterasys X-Pedition 8000/8600 Getting Started Guide
LEDs
Table 6. SSR-GLX39-04 and SSR-GSX31-04 LED Indicators
LED Condition Status
Offline On The line card is offline (powered off) and ready to hot swap.
This LED also lights briefly whey you reboot or reset the
X-Pedition but turns off as soon as the control module discovers
the SSR-GLX39-04 or SSR-GSX31-04.
Online On The SSR-GLX39-04 or SSR-GSX31-04 is ready to receive,
process, and send packets (if configured).
Per-Port Link Green Indicates that the port hardware detected the cable plugged into
the port and a good link is established.
Red
(intermittent)
The port received an error during operation.
Red The port hardware detected a cable plugged into the port, but a
bad link was established.
Off No link from the port exists.
Per-port Rx Green The port’s transceiver is receiving packets.
Amber The port’s transceiver is receiving flow-control packets.
Per-port Tx Green The port’s transceiver is transmitting packets.
Amber The port’s transceiver is transmitting flow-control packets.
Per-port AN Green The line card auto-negotiated the operating mode of the link
between full-duplex and half-duplex.
Amber
(intermittent)
Auto-Negotiation is in progress.
Amber Indicates a problem with Auto-Negotiation configuration.
Red An Auto-Negotiation failure occurred.This fault may occur if the
link partner does not support full-duplex operation.
Off Auto-Negotiation is disabled or the link is down.