Filter
Top Products
Configuring for VLANs
5-42
To enable or disable GVRP (RoamAbout R2 only):
1. Click the VLAN Parameters button.
2. Enable or disable GVRP.
3. Click OK.
To enable or disable VLAN compatibility on the AP 2000:
1. Click the VLAN Parameters button.
2. Enable or disable Allow Tagged Packets.
3. Click OK.
Using the RoamAbout R2 Web Management
To access the VLAN configuration pages, click on the VLANs/Multicast Groups folder.
Using the RoamAbout R2 Console Port
The R2 console port/Telnet interface does not support configuring VLANs. However, you
can enable or disable GVRP as follows. A reset is not needed to implement VLAN changes.
1. Choose Network Configuration from the Main Menu.
2. Enable or disable GVRP.
3. Choose Save.
Using the Access Point 2000 Console Port
A reset is not needed to implement VLAN changes.
1. Choose Module-Specific Options from the Installation Menu.
2. Choose VLAN Options.
Set VLAN Compatibility Mode: Enable to forward VLAN data. Disable to not
forward VLAN data.
3. Choose Save.