Filter
Top Products
Setting SNMP Trap Addresses (Access Point Only)
7-26
Setting SNMP Trap Addresses (Access Point Only)
To have the AP send SNMP traps, you need to enter the IP address of the device where the
trap is to be sent. A trap is a defined event or condition detected by the RoamAbout AP
SNMP agent.
The AP sends an SNMP trap when any of the following events occur:
• AP is powered on (coldstart trap).
• Ethernet network connection is established (network link up trap).
• User tried to communicate with the AP using an incorrect SNMP community string
(authentication trap).
To enter an SNMP trap address using the console port:
1. Choose Add SNMP Trap Addresses from the RoamAbout AP Installation Menu.
2. Enter the IP address of the system that you want to receive the SNMP traps.
If you do not want to change the existing value, press <Enter> to go back to the
previous menu.
To delete an existing trap address using the console port:
1. Choose Delete SNMP Trap Addresses from the RoamAbout AP Installation Menu.
2. Enter the IP address of the system that you no longer want to send SNMP traps.
NOTE: This feature is not available on the RoamAbout R2.
NOTE