Filter
Top Products
7-27
Setting Upline Dump (Access Point Only)
Setting Upline Dump (Access Point Only)
The Upline Dump mode is disabled by default. This option allows you to specify whether
the AP uploads diagnostic information about itself in the event of a crash. This option
should be DISABLED unless a support representative tells you otherwise.
The Upline Dump setting is available by clicking the Network Parameters button in the
AP Manager, or selecting the Module-Specific Options in the console port RoamAbout
AP Installation Menu.
When enabled, you can select one of the following:
• Use the BootP Server to discover the IP address of the destination TFTP server and the
destination directory on that server.
• Upload the image to the specified TFTP server IP address and a destination directory.
NOTE: This feature is not available on the RoamAbout R2.
NOTE: You must use the path structure dictated by your operating system.
Depending on the dump host, you may need to create a writable file to
accept the dump. The file name should be apxxxxxx.dmp, where xxxxxxx is
the last 6 digits of the AP’s wired MAC address.
NOTE
NOTES