Filter
Top Products
22 Using Optional Equipment
5. Slide the transparency unit forward slightly until the two holes in front of these
slots are aligned with the screw holes at the back of the scanner.
6. Insert the two installation screws that came with the transparency unit into the
screw holes, then tighten the screws with a coin.
7. Gently close the transparency unit.
8. Connect the transparency unit
cable to the
OPTION connector at
the back of the scanner. Tighten
the attached screws.
See “Using EPSON Scan” on page 6
for scanning instructions.
1680.book Page 22 Wednesday, April 9, 2003 4:09 PM