Filter
Top Products
Using Optional Equipment 29
Installing the Automatic Document Feeder
Caution: Because the automatic document feeder is heavy, you may want to
have someone help you with this procedure.
1. Make sure your scanner is turned off.
2. Remove your scanner’s document cover by
grasping the back of the cover as shown
and easing it straight up.
3. Make sure the document table is clean and
dust free.
4. Position the automatic
document feeder’s mounting
slots over the two mounting
screws located at the back of
the scanner.
5. Slide the automatic document
feeder forward slightly until
the two holes in front of these
slots are aligned with the screw
holes at the back of the
scanner.
Don’t remove the foam
block until you’re done
installing the unit.
1680.book Page 29 Wednesday, April 9, 2003 4:09 PM