8 1 • Installation
Connecting to a PC desktop computer
Before beginning, make sure that the projector and computer are both
turned off.
1. Connect either end of the computer cable to the projector’s
Computer In 1 port. The Computer In 2 port is used when
connecting a second computer.
2. Disconnect the computer’s monitor cable from the computer’s
monitor port and connect the other end of the computer cable to
this port.
3. If necessary, connect the monitor cable of the computer monitor
to the projector’s Monitor port.
4. Connect the small end of the main cable to the projector’s
Mouse/Com 1 port. The Mouse/Com 2 port is used when you
are connecting a second computer.
5. Connect the PS/2 mouse cable (9-pin) to the mouse terminal
on the large end of the main cable.
6. Disconnect the computer’s mouse cable from the mouse port on
the back of your computer and connect the mouse connector
(6-pin) of the PS/2 mouse cable to the mouse port.
7. If you are planning to use the ELP Link II software, connect
either end of a PC serial cable to the PC SERIAL terminal on the
large end of the main cable.
8. Connect the other end of the PC serial cable to the serial port on
the back of your computer.
9. Tighten all connector screws to ensure secure connections.
• Note that you will not be able to use the ELP Link II software
if your system does not have two serial ports.