Filter
Top Products
20 2 • Using the Projector
Turning the Equipment On and Off
Always turn on the projector and its attached equipment in the
following order.
1. Video source
2. Audio source (if different than computer or video source)
3. Projector
4. External speaker or PA system
5. Computer
Remove the projector’s lens cap before turning on projector. The
operation indicator will flash for a while and then light up to indicate
that power is on. If a computer or video equipment is attached to the
projector, the video signal or computer signal from the attached
equipment will be projected. It will take at least 30 seconds after
turning the power on before a normal image appears.
◆
Warning:
Never look into the lens when the lamp is on. This can
damage your eyes. It is especially important that children are not
allowed to look into the lens.
◆
Note:
Remove the projector’s lens cap when you project. The light
from the projector may cause the lens cap to warp.
Reverse the order shown above to turn off the projector and other
equipment. After you press the Power button to turn off the projec-
tor, the fan will remain on and the operation indicator will flash
orange for about one minute as the projector cools. The indicator
stops blinking (and remains lit in orange) when the cooling operation
is complete.