Filter
Top Products
13
Before Using the Remote Control
Using the Remote Control and Remote Operating
Range
The remote control is used in the following way.
PROCEDURE
Point the remote control light-emitting area toward one of
the remote control light-receiving areas on the projector
and operate the remote control buttons.
Using the Remote Control
Remote control
light-receiving
area (front)
Remote control
light-receiving
area (back)
Remote control
light-emitting area
TIP
•Do not allow sunlight or light from fluorescent lamps to shine
directly onto the projector's remote control light-receiving areas,
otherwise it may interfere with the reception of signals from the
remote control.
•If delays in the responsiveness of the remote control occur or if it
does not operate after it has been used for some time, it probably
means that the batteries are getting flat. If this happens, replace the
batteries with new ones. sp.12
•If any of the buttons on the remote control are pressed down for
more than 30 seconds, the remote control stops to send signals
(remote control's sleep mode) . The purpose of this is to prevent the
batteries from being consumed due to something being placed on top
of the remote control.
When the button is released, normal remote control operation will
resume.