Filter
Top Products
73
Problems Solving
Lamp replacement notification Replace the lamp with a new one. sp.86
If you continue to use the lamp after it has passed the replacement period, the possibility that the
lamp may break will increase. Replace the lamp with a new one as soon as possible. The Power
indicator status will vary depending on the projector status at the time.
Power indicator lights green or orange/flashes green or orange
: lit : flashing : off
Status Cause Remedy or Status
Standby condition Projection starts again when the [Power] button is pressed.
You can disconnect the power plug from the electrical outlet when the status light is in this
condition.
Warm-up in progress Warm-up time is approximately 40 seconds. After warm-up is complete, the indicator stops
flashing.
Projection in progress
Cool-down in progress Please wait.
•The cool-downg period lasts about 20 seconds.
•The [Power] button will not operate if it is pressed while cool-down is in progress. When the
cool-down period is finished and the confirmation buzzer has sounded and the indicator changes
to light orange, repeat the operation.
: lit : flashing : off
Status Cause Remedy or Status
Orange
Power
Normal
OrangePower
GreenPower
GreenPower
OrengePower
TIP
•If the projector is not operating properly even though the indicators are all showing normal, refer to "When the Indicators Provide No Help"
on the following page.
•If an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided in the
"International Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.