Filter
Top Products
76
Problems Solving
Projection stops automatically
The message "Not Supported." is displayed
Check Remedy
Is "Sleep Mode" set to "ON"? When the "Sleep Mode" menu command has been set to "ON", the lamp turns off automatically if
no operations are carried out for about 30 minutes while no video signal is being input. The Power
indicator will flash orange at this time. Press the [Power] button to turn the power on. If you do not
want sleep mode to be used, change the "Sleep Mode" setting to "OFF".
"Extended" - "Operation" - "Sleep Mode" sp.62
Check Remedy
Are the image signal format settings correct? If a composite videog or S-Videog source is connected to the projector, use the "Video Signal"
menu command to select the signal format.
"Signal" - "Video Signal" sp.57
Does the mode match the frequency and
resolution of the image signals?
Refer to the documentation provided with your computer for details on changing the resolution and
frequency of the image signals being output from the computer.
"List of Supported Monitor Displays" sp.99
Only when projecting images
from a video source
Only when projecting computer images