Filter
Top Products
Using the Printer
2-3
2
About Your Printer’s Default Settings
The default settings control many printer functions. While you
can often set these functions through your software or printer
driver, you may sometimes need to change a default setting from
the printer’s control panel using the Default Setting mode.
The following table lists the default settings and the options you
can select in the Default Setting mode. The settings are explained
in detail after the table. For instructions on changing the default
settings, see “Changing default settings” on page 2-9.
Settings Options
Page length for tractor* Length in inches: 3, 3.5, 3.66, 4, 4.5, 5.5,
6, 7, 8, 8.5, 11, 70/6, 12, 14
Skip over perforation On, Off
Auto tear off On, Off
Auto line feed On, Off
Print direction Bi-D, Uni-D, Auto
Software ESC/P2, IBM PPDS
0 slash 0,
High speed draft On, Off
I/F mode Auto, Parallel, Serial
Auto I/F wait time 10 seconds, 30 seconds
Baud rate 19200, 9600, 4800, 2400, 1200, 600, 300
BPS
Parity None, Even, Odd, Ignore
Data length 8 bit, 7 bit
Parallel I/F bidirectional
mode
On, Off
* The options available vary depending on the country of purchase.
** These settings take effect only when IBM PPDS emulation is selected.
0