Filter
Top Products
2-36
Using the Printer
7. Take a stack of paper and fan it. Next, tap the side and bottom
of the paper on a flat surface to even up the stack.
c
Caution:
Do not use envelopes, multipart forms, carbon paper, or
labels in the cut-sheet feeder.
8. Insert up to 50 sheets of paper along the left paper guide.
9. Adjust the position of the right paper guide so that it matches
your paper’s width. Make sure the position of the guide
allows the paper to move up and down freely.
10. Push the paper-set levers back to clamp the paper against the
guide rollers.
11. Remove the paper supports from the edge guides and insert
the two stacker supports packed with the cut-sheet feeder into
the holes on the edge guides.
12. Attach the paper guide to the cut-sheet feeder as shown
below.
View from above
Release tab
Release tab