Filter
Top Products
i
MLC 104 IP Plus • Table of Contents
Table of Contents
Chapter One • Introduction ...................................................1-1
About this Manual ....................................................................1-2
About the MLC 104 IP Plus Medialink
™
Controllers ........1-2
About Global Configurator ....................................................1-3
System Requirements ...............................................................1-4
Installing the Software ............................................................1-5
Updating Firmware ...................................................................1-5
Chapter Two • MLC 104 IP Plus Hardware Setup .....2-1
Right Side Panel Features and Connections .....................2-2
Left Side/Top Panel Features and Connections ...............2-8
Front Panel Features and Basic Operation ......................2-10
Buttons .................................................................................2-10
Volume control .....................................................................2-11
Configuration (host control) port .......................................2-11
Chapter Three • MLC 104 IP Plus Software Setup ...3-1
Step 1: Download Device Drivers .......................................3-3
Step 2: Create a New Project ............................................... 3-4
Step 3: Add an MLC 104 IP Plus Controller and Define
its Location...................................................................................3-5
Step 4: Define E-mail Settings ............................................3-7
Defining e-mail server settings .............................................3-7
Setting up e-mail notifications .............................................3-8
Adding e-mail contacts ..........................................................3-9
Step 5: Add a Serial and an IR Device ..............................3-10
Downloading additional drivers .........................................3-10
Adding a serial driver .........................................................3-11
Adding an IR driver ..............................................................3-12
Step 6: Configure the Front Panel Buttons ....................3-13
Configuring an input button ...............................................3-14
Configuring the On and Off buttons ..................................3-14
Step 7: Configure the Control Modules Using the
Auto Fill Feature .......................................................................3-15
Step 8: Create a Display Shutdown Schedule ...............3-18
Step 9: Create a Display Lamp Hour Warning E-mail 3-20
Step 10: Create a Display Disconnection E-mail .........3-22