Filter
Top Products
5-118
118 | Maintaining and Transporting the Printer
•
To change the units of measurement, press the button until you
see
UNIT, then press the Menu button. Press the button to
switch from
METER to FEET/INCH, then press Menu to select
the units you want. Press the button when done.
• To change the default cutting pressure, press the button until you
see
CUT PRESSURE, then press the Menu button to display
100%. Press the button to decrease the pressure, or the button
to increase it (in 1% increments). Press
Menu to select the
setting you want.
• To run a super strong cleaning cycle, press the button until you
see
SSCL, then press the Menu button to display EXEC. Press
Menu to start the cleaning cycle.
• To return all control panel settings to their default values, press the
the
button until you see DEFAULT PANEL, then press the
Menu
button to display EXEC. Press Menu again to restore
the default settings.
3. To exit the maintenance mode, turn off the printer by pressing the
P Power button. Press the P Power button again to turn on the printer
in the normal operating mode.
Replacing the Paper Cutter Blade
If you notice that your paper isn’t being cut cleanly, the cutter blade may
need to be replaced. If you use the blade to cut heavy stock, you will damage
the blade and need to replace it. See page 48 for a list of media that do not
work with the cutter.
You can check the status of your cutter by printing the status check sheet or
viewing its status on the control panel. See page 103 for instructions.
You can obtain a new cutter blade from Epson (part number C12C815291).
Make sure the printer is on, then follow these steps to replace the blade:
1. Press the
Menu button.
2. Press the button until you see
CUTTER REPLACE.
3. Press
Menu to display EXEC.
Note: You can purchase
replacement blades from
an authorized Epson
reseller. To find the
nearest reseller, call
800-GO-EPSON
(800-463-7766). In the
U.S., you can also
purchase online at
www.epsonstore.com.
In Canada, you can also
purchase at
www.epson.ca or
800-807-7766.
sp4800Guide.book Page 118 Tuesday, March 7, 2006 3:49 PM