Filter
Top Products
Basic Operations 104
Using a Test Pattern
Primary and Secondary adjustments are required. Normally the Secondary adjustment
is performed after the Primary adjustment. Primary adjustment alone may be sufficient if
you only wish to accurately print the length of a design.
1. After confirming that the printer is ready to print, press the Menu button.
The settings menu will be displayed.
2. Select Media Setup and press the Z button.
3. Use the d/u buttons to select Customize Settings and press the Z button.
4. Use the d/u buttons to select a media setting bank number between 1 and 30 and then
press the Z button.
Note that any settings already saved in the printer will be overwritten.
5. Use the d/u buttons to select Feed Adjustment and press the Z button.
6. Select Manual and press the Z button.
Primary Adjustment
7. Select Primary and press the Z button.
8. Use the d/u buttons to select a test pattern and press the Z button twice.
The longer the pattern, the more accurate the adjustment.
9. The printer will print a test pattern.